基于能动分块反射镜的七路激光阵列倾斜校正与相干合成实验研究

提出了一种基于能动分块反射镜(ASM)的激光阵列相位控制新方法,用以解决激光主振荡功率放大(MOPA)器相干合成技术中的空间光束倾斜校准与输出端相位调制两大关键问题。介绍了7单元能动分块反射镜实现空间光调制的原理,并采用该器件成功验证了7路光束合成的方案。实验采用六棱反射锥进行光束合成,并采用两套控制回路分别实现了倾斜与平移校正,获得了小于25μrad和λ/10的校正精度。闭环后,获得了主瓣占总功率31.73%的高质量相干耦合激光输出。     

1030nm高重复频率纳秒脉冲全光纤放大器

采用脉冲调制的单模带尾纤输出的半导体激光器作为种子源,以掺镱光纤为增益介质,采用主振荡功率放大(MOPA)结构,实现了1030nm全光纤脉冲激光放大。脉冲重复频率在50～100kHz范围内可调,在重复频率50kHz时,实现了脉冲宽度为6.53ns,峰值功率为16.08kW的脉冲输出,相应的斜率效率为69%,输出激光的中心波长在1029.49nm。实验还研究了不同重复频率下输出激光脉冲的时域特性。该激光器的输出波长在激光雷达探测器的光谱响应范围内,可作为激光雷达发射光源。     

低功率抽运光纤参量振荡器的时钟提取抖动性能

采用两次光调制技术将非归零(NRZ)码数据转换成归零(RZ)码光信号后,利用光纤参量振荡器(FOPO)结构实现了较低光功率抽运下的参量波长转换和时钟提取功能。实验表明,对于波长转换间隔为1.6nm的10Gbit/s时钟提取,优化的输入抽运光功率范围是8～14dBm;当输入信号的幅度抖动和相位抖动分别大于2.28mV和3.5ps时,该时钟提取系统可实现抖动抑制功能,其输入/输出抖动转移曲线斜率约为0.29和0.16。     

波长间隔可调谐多波长光纤光学参量振荡器

提出并实现了一种以高非线性色散位移光纤为增益介质,以光栅对形成谐振腔,简单线形结构的连续光抽运的波长间隔可调谐多波长光纤光学参量振荡器(MW-FOPO)。采用波长可调谐的窄线宽激光器作为抽运种子光源,以伪随机相位调制抽运光来抑制高非线性光纤中的受激布里渊(SBS)散射效应,结合高功率掺铒光纤放大器构成光纤光学参量振荡器的大功率抽运,通过四波混频(FWM)效应获得了室温下稳定的多波长激光输出。MW-FOPO的波长间隔可以通过调节抽运波长进行调谐。在1505~1615 nm光谱范围内,获得了17条消光比大于10 dB的多波长谱线。实验证明了MW-FOPO实现多波长激光光源的优异特性。     

Reliability analysis of MOS varactor in CMOS LC VCO

The paper investigates the reliability of MOS varactor tuned voltage-controlled oscillators (VCO). Due to the stress induced threshold voltage shift of the MOS varactor, the resonant tank degrades and the center frequency and phase noise of VCO deviate. The behavior is modeled and an adaptive body biasing scheme is proposed to make VCO resilient to reliability. In the mean time it does not degrade the VCO performance. An LC VCO at 24 GHz carrier frequency with adaptive body biasing is compared with VCO without such biasing design in PTM 65 nm technology. The ADS simulation results show that the biasing design helps improve the robustness of the VCO in resonant frequency. The design reduces the frequency sensitivity of VCO by 20% when subjected to threshold voltage degradation.     

Resistorless dual-mode quadrature sinusoidal oscillator using a single active building block

This paper presents a new realization of resistorless mixed-mode (i.e. both voltage-mode and current-mode) quadrature sinusoidal oscillator using a new active building block (ABB) called the differential voltage current-controlled conveyor transconductance amplifier (DVCCCTA). The proposed oscillator circuit uses a single DVCCCTA, two grounded capacitors (GCs) and does not employ any external linear resistors. The tuning laws for the condition of oscillation (CO) and the frequency of oscillation (FO) are non-interactive; and controlled by separate bias currents. The circuit provides two explicit quadrature current outputs and two quadrature voltage outputs and thus can be classified as a mixed-mode quadrature oscillator. Another notable feature of the proposed circuit is that it can also be used as a biquadratic filter to realize low-pass and band-pass filtering functions simultaneously. Non-ideal analysis of the circuit is provided and PSpice simulation results have been included to verify the workability of the proposed circuit.     

3mm二次谐波回旋振荡管设计与数值模拟

二次谐波回旋振荡管的互作用磁场比基波回旋振荡管的磁场降低了一半,从而降低了设计难度,具有广阔的应用前景。通过对单腔结构的W波段二次谐波回旋振荡管高频结构、起振电流、模式竞争以及注波互作用研究,确定了W波段TE02模二次谐波回旋振荡管的基本工作参数,通过粒子模拟(PIC)软件进行计算,在电子注电压为60kV,注电流为6A及速度比为1.5时,获得了67.5kW的输出功率和超过18%的效率,且工作稳定。     

LC振荡器相位噪声的非线性摄动分析技术

相位噪声是振荡器的重要性能指标,通过对振荡器的非线性微分方程的推导,从而引入新的参数来考虑振幅噪声和相位噪声之间的相关性同时把这些参数和振荡器的工作点联系起来。并且这些公式推导也考虑了LC谐振回路中振幅噪声和相位噪声之间的相关性。在此基础上这里研究了如何在时域状态方程下将噪声看成是对振荡输出信号的小扰动,并建立引入噪声后的随机微分方程,实现LC振荡器的相位噪声分析技术。     

基于PZT陶瓷谐振技术的光纤相位调制器研究

分析影响了基于压电陶瓷谐振换能器的光纤相位调节的主要参数,并根据参数研制出一种满足性能要求的压电陶瓷光纤相位调制器.结果表明,光纤伸长位移量与光纤直径、压电常数、工作电压及陶瓷直径有关,与压电陶瓷的厚度无关;压电陶瓷光纤相位调制器的具有工作频率高(100 kHz以上),驱动电压低(2～3 V),电容小,介电损耗小,自滤波谐振等特点.     

1.2V低功耗时钟发生器设计

基于整数分频锁相环结构实现的时钟发生器,该时钟发生器采用低功耗、低抖动技术,在SMIC 65 nm CMOS工艺上实现。电路使用1.2 V单一电源电压,并在片上集成了环路滤波器。其中,振荡器为电流控制、全差分结构的五级环形振荡器。该信号发生器可以产生的时钟频率范围为12.5～800MHz,工作在800 MHz时所需的功耗为1.54 mW,输出时钟的周期抖动为:pk-pk=75 ps,rms=8.6 ps;Cycle-to-Cycle抖动为:pk-pk=132 ps,rms=14.1 ps。电路的面积为84μm2。